Billion 7300 Series fetchtv Configuration

This guide is for configuring your hardware to work over an existing Internode ADSL service to access fetchtv Full. Below are instructions for configuring fetchtv to work using the Billion 7300RA or 7300GRA modem/router.

Step 1

• Open your web browser (e.g. Internet Explorer, Mozilla Firefox or Safari if using a Mac)

• Remove everything from the address bar including the "http://" so the field is completely blank and type "192.168.1.254" and press the enter key.

• Log in to the modem with the username admin and password admin.

• Click the Advanced link located at the top of the page.

Step 2

• Click the Configuration link on the left side of the page.

• Click the WAN link on the left side of the page, then click WAN Profile.

Step 3

• Select Pure Bridge from the Protocol drop down box.
• Type 8 into the VPI text box
• Type 34 into the VCI text box
• Type IPTV into the description text box
• Click the Add button on the bottom left of the page

Step 4

• Click the Advanced link on the left side of the page
• Click the IGMP link below that.

Step 5

• Set the IGMP Forwarding radio button to Disable
• Set the IGMP Snooping radio button to Enable
• Click the Apply button.

Step 6

• Click the Save Config button at the bottom-right of the page.
• Click the Apply button to save the settings to the modem.

The modem is now configured to use the fetchtv service. You can now plug your modem into any of the 4 ethernet ports and turn on the fetchtv set top box.