Billion 740x VG Series fetchtv Configuration

This guide is for configuring your hardware to work over an existing Internode ADSL service to access fetchtv Full. Below are instructions for configuring fetchtv to work using the following routers:

• Billion 7401VGP
• 7401VGP-M
• 7402VGP
• 7404VG
• 7404VGO-M
• 7404VGP
• 7404VGP-M

Step 1

• Open your web browser (e.g., Internet Explorer, Mozilla Firefox or Safari if using a Mac)
• Remove everything from the address bar including the "http://" so the field is completely blank and type "192.168.1.254" and press the enter key.

• Log in to the modem with the username admin and password admin.

• Click the Configuration link on the left side of the page.

Step 2

• Click the WAN link on the left of the page.

• Click the ISP link on the left side of the page.

Step 3

• Click the Create link in the middle of the page.

Step 4

• Set the ATM radio button to RFC 1483 Bridged then click the Next button.

Step 5

• Type 34 into the VCI textbox then click the Apply button.

Step 6

• Click the Advanced link on the left side of the page.

• Click the IGMP link on the left side of the page.

Step 7

• Set the IGMP Forwarding radio button to Disable.
• Set the IGMP Snooping radio button to Enable.

• Click the Apply button.

Step 8

• Click the LAN link on the left side of the page.

• Click the Bridge Interface link on the left side of the page.

Step 9

• Un-tick the Port number that your fetchtv set top box is connected to and tick ethernet1 on the appropriate port (The screenshot shown is if the fetchtv set top box was plugged into Port 3 on the modem.) Please Note - Ethernet port 1 is unable to be configured to connect to the fetchtv set top box.

• Once completed, click the Apply button.

Step 10

• Click the Save Config button located down the bottom-right of the page.

Step 11

• Click the Apply button

• You can now plug the fetchtv set top box into the modem's ethernet port specified in step 9.

With the fetchtv set top box turned OFF, restart your modem by either switching the modem power off for 1 minute or selecting restart with current settings on the bottom right of the page. (This will preserve your settings.) Once the modem has been turned back on, you can then turn the power to your fetchtv set top box ON.